Filter News
Area of Research
- (-) Advanced Manufacturing (2)
- (-) Neutron Science (3)
- Biology and Environment (1)
- Clean Energy (8)
- Computational Engineering (1)
- Computer Science (4)
- Fuel Cycle Science and Technology (1)
- Fusion Energy (4)
- Materials (14)
- National Security (2)
- Nuclear Science and Technology (13)
- Quantum information Science (3)
- Supercomputing (11)
News Type
News Topics
- (-) Composites (2)
- (-) Nuclear Energy (2)
- (-) Quantum Science (1)
- 3-D Printing/Advanced Manufacturing (9)
- Advanced Reactors (1)
- Bioenergy (3)
- Biomedical (3)
- Clean Water (1)
- Computer Science (3)
- Cybersecurity (1)
- Energy Storage (3)
- Environment (4)
- Fusion (1)
- Machine Learning (1)
- Materials Science (5)
- Microscopy (1)
- Nanotechnology (1)
- Neutron Science (21)
- Physics (3)
- Sustainable Energy (1)
- Transportation (1)
Media Contacts
A team including Oak Ridge National Laboratory and University of Tennessee researchers demonstrated a novel 3D printing approach called Z-pinning that can increase the material’s strength and toughness by more than three and a half times compared to conventional additive manufacturing processes.
Using additive manufacturing, scientists experimenting with tungsten at Oak Ridge National Laboratory hope to unlock new potential of the high-performance heat-transferring material used to protect components from the plasma inside a fusion reactor. Fusion requires hydrogen isotopes to reach millions of degrees.
Researchers at the Department of Energy’s Oak Ridge National Laboratory, Pacific Northwest National Laboratory and Washington State University teamed up to investigate the complex dynamics of low-water liquids that challenge nuclear waste processing at federal cleanup sites.
Researchers used neutron scattering at Oak Ridge National Laboratory’s Spallation Neutron Source to investigate bizarre magnetic behavior, believed to be a possible quantum spin liquid rarely found in a three-dimensional material. QSLs are exotic states of matter where magnetism continues to fluctuate at low temperatures instead of “freezing” into aligned north and south poles as with traditional magnets.
Scientists at the Department of Energy’s Oak Ridge National Laboratory have created a recipe for a renewable 3D printing feedstock that could spur a profitable new use for an intractable biorefinery byproduct: lignin.