331 - 340 of 1959 Results
Anisotropic bonded critical rare earth free permanent magnets in a polymer matrix fabricated using an additive manufacturing process.
Free-standing, thin films were fabricated with a binder resulting in nearly an order of magnitude thickness decrease while increasing porosity and activation energy. These effects of such diminished significantly. Free-standing films could be fabricated with a binder.
Compliance in a part, work holding, or base plate is beneficial for certain processes, but detrimental for machining and material removal.
This technology creates a light and metalless current collector for battery application. Cathodes coated on this new current collector demonstrated similar contact resistance, lower charge transfer resistance and similar or high rate performance.
In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.
Porous carbons are the primary and imperative active materials for commercial supercapacitors because of their power capability, long-term cycle stability, wide operating temperatures, and high Coulombic efficiencies.
Additively manufacturing of the windings with a conductor distributed in the cross-section according to the Hilbert curve provides many benefits as it allows for the reduction of the high-frequency losses due to the reduction of the effective winding conductor size.
We propose an efficient data memory management for the IRIS heterogeneous computing framework along with data transfer policies to select an efficient data transfer between heterogeneous computing units.
A deposition tool was developed that enables rehabilitating lining application within live natural gas pipelines without requiring trenching and removal/replacement of the pipelines. This lining technology creates a fully renewed pipeline.