Filter News
Area of Research
- (-) Advanced Manufacturing (4)
- (-) Neutron Science (6)
- Biology and Environment (84)
- Biology and Soft Matter (1)
- Clean Energy (64)
- Climate and Environmental Systems (4)
- Computational Engineering (1)
- Computer Science (1)
- Fusion and Fission (7)
- Fusion Energy (6)
- Isotopes (19)
- Materials (27)
- Materials for Computing (1)
- Mathematics (1)
- National Security (15)
- Nuclear Science and Technology (13)
- Nuclear Systems Modeling, Simulation and Validation (1)
- Quantum information Science (1)
- Supercomputing (33)
- Transportation Systems (1)
News Topics
- (-) Advanced Reactors (1)
- (-) Composites (3)
- (-) Decarbonization (1)
- (-) Environment (4)
- (-) Space Exploration (3)
- 3-D Printing/Advanced Manufacturing (15)
- Artificial Intelligence (5)
- Big Data (1)
- Bioenergy (3)
- Biology (1)
- Biomedical (7)
- Chemical Sciences (2)
- Clean Water (2)
- Computer Science (7)
- Coronavirus (3)
- Energy Storage (4)
- Fossil Energy (1)
- Fusion (1)
- High-Performance Computing (1)
- Machine Learning (3)
- Materials (12)
- Materials Science (14)
- Mathematics (1)
- Microscopy (2)
- Nanotechnology (3)
- National Security (1)
- Neutron Science (56)
- Nuclear Energy (3)
- Physics (2)
- Polymers (1)
- Quantum Computing (1)
- Quantum Science (2)
- Security (1)
- Summit (2)
- Sustainable Energy (3)
- Transportation (2)
Media Contacts
How did we get from stardust to where we are today? That’s the question NASA scientist Andrew Needham has pondered his entire career.
Natural gas furnaces not only heat your home, they also produce a lot of pollution. Even modern high-efficiency condensing furnaces produce significant amounts of corrosive acidic condensation and unhealthy levels of nitrogen oxides
A research team at Oak Ridge National Laboratory have 3D printed a thermal protection shield, or TPS, for a capsule that will launch with the Cygnus cargo spacecraft as part of the supply mission to the International Space Station.
Researchers from NASA’s Jet Propulsion Laboratory and Oak Ridge National Laboratory successfully created amorphous ice, similar to ice in interstellar space and on icy worlds in our solar system. They documented that its disordered atomic behavior is unlike any ice on Earth.
Oak Ridge National Laboratory researchers combined additive manufacturing with conventional compression molding to produce high-performance thermoplastic composites reinforced with short carbon fibers.
Illustration of the optimized zeolite catalyst, or NbAlS-1, which enables a highly efficient chemical reaction to create butene, a renewable source of energy, without expending high amounts of energy for the conversion. Credit: Jill Hemman, Oak Ridge National Laboratory/U.S. Dept. of Energy
A team including Oak Ridge National Laboratory and University of Tennessee researchers demonstrated a novel 3D printing approach called Z-pinning that can increase the material’s strength and toughness by more than three and a half times compared to conventional additive manufacturing processes.
Using additive manufacturing, scientists experimenting with tungsten at Oak Ridge National Laboratory hope to unlock new potential of the high-performance heat-transferring material used to protect components from the plasma inside a fusion reactor. Fusion requires hydrogen isotopes to reach millions of degrees.
Researchers at the Department of Energy’s Oak Ridge National Laboratory, Pacific Northwest National Laboratory and Washington State University teamed up to investigate the complex dynamics of low-water liquids that challenge nuclear waste processing at federal cleanup sites.
Researchers used neutron scattering at Oak Ridge National Laboratory’s Spallation Neutron Source to investigate the effectiveness of a novel crystallization method to capture carbon dioxide directly from the air.