Filter News
Area of Research
News Type
News Topics
- (-) 3-D Printing/Advanced Manufacturing (4)
- (-) Cybersecurity (1)
- (-) Materials Science (1)
- (-) Physics (1)
- Buildings (5)
- Chemical Sciences (5)
- Composites (1)
- Computer Science (1)
- Critical Materials (4)
- Decarbonization (4)
- Energy Storage (9)
- Environment (1)
- Grid (5)
- Hydropower (1)
- Materials (8)
- Nanotechnology (2)
- National Security (1)
- Neutron Science (1)
- Polymers (2)
- Quantum Computing (2)
- Security (1)
- Simulation (1)
- Sustainable Energy (2)
- Transportation (7)
Media Contacts
An Oak Ridge National Laboratory-developed advanced manufacturing technology, AMCM, was recently licensed by Orbital Composites and enables the rapid production of composite-based components, which could accelerate the decarbonization of vehicles
Oak Ridge National Laboratory researchers have conducted a comprehensive life cycle, cost and carbon emissions analysis on 3D-printed molds for precast concrete and determined the method is economically beneficial compared to conventional wood molds.
Carl Dukes’ career as an adept communicator got off to a slow start: He was about 5 years old when he spoke for the first time. “I’ve been making up for lost time ever since,” joked Dukes, a technical professional at the Department of Energy’s Oak Ridge National Laboratory.
Andrea Delgado is looking for elementary particles that seem so abstract, there appears to be no obvious short-term benefit to her research.
A new report published by ORNL assessed how advanced manufacturing and materials, such as 3D printing and novel component coatings, could offer solutions to modernize the existing fleet and design new approaches to hydropower.
Warming a crystal of the mineral fresnoite, ORNL scientists discovered that excitations called phasons carried heat three times farther and faster than phonons, the excitations that usually carry heat through a material.
ORNL researchers have identified a mechanism in a 3D-printed alloy – termed “load shuffling” — that could enable the design of better-performing lightweight materials for vehicles.