Filter News
Area of Research
News Topics
- (-) 3-D Printing/Advanced Manufacturing (4)
- (-) Environment (5)
- (-) Materials Science (1)
- Bioenergy (8)
- Biology (6)
- Biotechnology (2)
- Buildings (4)
- Chemical Sciences (4)
- Climate Change (1)
- Composites (1)
- Computer Science (3)
- Coronavirus (1)
- Critical Materials (3)
- Decarbonization (4)
- Energy Storage (5)
- Grid (3)
- Hydropower (1)
- Irradiation (1)
- Materials (5)
- Mercury (1)
- Nanotechnology (1)
- Neutron Science (5)
- Polymers (1)
- Quantum Computing (3)
- Quantum Science (2)
- Simulation (2)
- Sustainable Energy (6)
- Transportation (8)
Media Contacts
An Oak Ridge National Laboratory-developed advanced manufacturing technology, AMCM, was recently licensed by Orbital Composites and enables the rapid production of composite-based components, which could accelerate the decarbonization of vehicles
Oak Ridge National Laboratory researchers have conducted a comprehensive life cycle, cost and carbon emissions analysis on 3D-printed molds for precast concrete and determined the method is economically beneficial compared to conventional wood molds.
Researchers from Oak Ridge National Laboratory and Northeastern University modeled how extreme conditions in a changing climate affect the land’s ability to absorb atmospheric carbon — a key process for mitigating human-caused emissions. They found that 88% of Earth’s regions could become carbon emitters by the end of the 21st century.
Oak Ridge National Laboratory scientists studied hot springs on different continents and found similarities in how some microbes adapted despite their geographic diversity.
In the search for ways to fight methylmercury in global waterways, scientists at Oak Ridge National Laboratory discovered that some forms of phytoplankton are good at degrading the potent neurotoxin.
Oak Ridge National Laboratory researchers developed a model framework that identifies ways to ensure wildlife can safely navigate their habitats while not unduly affecting infrastructure.
A new report published by ORNL assessed how advanced manufacturing and materials, such as 3D printing and novel component coatings, could offer solutions to modernize the existing fleet and design new approaches to hydropower.
Warming a crystal of the mineral fresnoite, ORNL scientists discovered that excitations called phasons carried heat three times farther and faster than phonons, the excitations that usually carry heat through a material.
ORNL researchers have identified a mechanism in a 3D-printed alloy – termed “load shuffling” — that could enable the design of better-performing lightweight materials for vehicles.