Filter News
Area of Research
- (-) Clean Energy (16)
- (-) Neutron Science (2)
- Advanced Manufacturing (4)
- Biology and Environment (5)
- Climate and Environmental Systems (1)
- Computational Engineering (1)
- Computer Science (5)
- Fusion Energy (3)
- Materials (7)
- National Security (1)
- Nuclear Science and Technology (2)
- Quantum information Science (1)
- Supercomputing (3)
News Topics
- (-) 3-D Printing/Advanced Manufacturing (7)
- (-) Clean Water (2)
- (-) Environment (7)
- (-) Grid (4)
- (-) Microscopy (2)
- Bioenergy (1)
- Biomedical (1)
- Buildings (4)
- Chemical Sciences (2)
- Composites (2)
- Computer Science (4)
- Critical Materials (1)
- Decarbonization (2)
- Energy Storage (8)
- Hydropower (1)
- Materials (3)
- Materials Science (5)
- Nanotechnology (1)
- Neutron Science (13)
- Nuclear Energy (1)
- Physics (1)
- Polymers (2)
- Quantum Science (1)
- Simulation (1)
- Space Exploration (1)
- Sustainable Energy (4)
- Transportation (11)
Media Contacts
An Oak Ridge National Laboratory-developed advanced manufacturing technology, AMCM, was recently licensed by Orbital Composites and enables the rapid production of composite-based components, which could accelerate the decarbonization of vehicles
Oak Ridge National Laboratory researchers have conducted a comprehensive life cycle, cost and carbon emissions analysis on 3D-printed molds for precast concrete and determined the method is economically beneficial compared to conventional wood molds.
A new report published by ORNL assessed how advanced manufacturing and materials, such as 3D printing and novel component coatings, could offer solutions to modernize the existing fleet and design new approaches to hydropower.
ORNL researchers Ben Ollis and Max Ferrari will be in Adjuntas to join the March 18 festivities but also to hammer out more technical details of their contribution to the project: making the microgrids even more reliable.
When aging vehicle batteries lack the juice to power your car anymore, they may still hold energy. Yet it’s tough to find new uses for lithium-ion batteries with different makers, ages and sizes. A solution is urgently needed because battery recycling options are scarce.
ORNL researchers have identified a mechanism in a 3D-printed alloy – termed “load shuffling” — that could enable the design of better-performing lightweight materials for vehicles.
A team of scientists found that critical interactions between microbes and peat moss break down under warming temperatures, impacting moss health and ultimately carbon stored in soil.
Researchers demonstrated that an additively manufactured hot stamping die can withstand up to 25,000 usage cycles, proving that this technique is a viable solution for production.
A team including Oak Ridge National Laboratory and University of Tennessee researchers demonstrated a novel 3D printing approach called Z-pinning that can increase the material’s strength and toughness by more than three and a half times compared to conventional additive manufacturing processes.
A detailed study by Oak Ridge National Laboratory estimated how much more—or less—energy United States residents might consume by 2050 relative to predicted shifts in seasonal weather patterns