Filter News
Area of Research
- (-) Clean Energy (48)
- (-) Materials (15)
- Advanced Manufacturing (11)
- Biology and Environment (8)
- Building Technologies (2)
- Climate and Environmental Systems (1)
- Computational Engineering (2)
- Computer Science (10)
- Electricity and Smart Grid (1)
- Fusion Energy (3)
- Isotopes (1)
- Materials for Computing (4)
- Mathematics (1)
- National Security (3)
- Neutron Science (23)
- Nuclear Science and Technology (4)
- Quantum information Science (3)
- Sensors and Controls (1)
- Supercomputing (17)
News Topics
- (-) 3-D Printing/Advanced Manufacturing (26)
- (-) Big Data (1)
- (-) Composites (9)
- (-) Computer Science (10)
- (-) Grid (15)
- (-) Machine Learning (2)
- (-) Neutron Science (4)
- (-) Quantum Science (1)
- (-) Space Exploration (3)
- Advanced Reactors (1)
- Artificial Intelligence (1)
- Bioenergy (2)
- Biology (2)
- Biomedical (2)
- Biotechnology (1)
- Buildings (13)
- Chemical Sciences (4)
- Clean Water (4)
- Climate Change (6)
- Coronavirus (3)
- Critical Materials (8)
- Decarbonization (4)
- Energy Storage (22)
- Environment (16)
- Fusion (2)
- High-Performance Computing (1)
- Hydropower (2)
- Isotopes (2)
- Materials (22)
- Materials Science (23)
- Mathematics (1)
- Mercury (1)
- Microscopy (6)
- Molten Salt (1)
- Nanotechnology (8)
- Net Zero (1)
- Nuclear Energy (4)
- Physics (2)
- Polymers (7)
- Quantum Computing (1)
- Simulation (1)
- Statistics (1)
- Sustainable Energy (27)
- Transportation (27)
Media Contacts
Electric vehicles can drive longer distances if their lithium-ion batteries deliver more energy in a lighter package. A prime weight-loss candidate is the current collector, a component that often adds 10% to the weight of a battery cell without contributing energy.
An Oak Ridge National Laboratory-developed advanced manufacturing technology, AMCM, was recently licensed by Orbital Composites and enables the rapid production of composite-based components, which could accelerate the decarbonization of vehicles
Oak Ridge National Laboratory researchers have conducted a comprehensive life cycle, cost and carbon emissions analysis on 3D-printed molds for precast concrete and determined the method is economically beneficial compared to conventional wood molds.
A new report published by ORNL assessed how advanced manufacturing and materials, such as 3D printing and novel component coatings, could offer solutions to modernize the existing fleet and design new approaches to hydropower.
Scientists at ORNL developed a competitive, eco-friendly alternative made without harmful blowing agents.
ORNL researchers Ben Ollis and Max Ferrari will be in Adjuntas to join the March 18 festivities but also to hammer out more technical details of their contribution to the project: making the microgrids even more reliable.
Warming a crystal of the mineral fresnoite, ORNL scientists discovered that excitations called phasons carried heat three times farther and faster than phonons, the excitations that usually carry heat through a material.
When aging vehicle batteries lack the juice to power your car anymore, they may still hold energy. Yet it’s tough to find new uses for lithium-ion batteries with different makers, ages and sizes. A solution is urgently needed because battery recycling options are scarce.
Critical Materials Institute researchers at Oak Ridge National Laboratory and Arizona State University studied the mineral monazite, an important source of rare-earth elements, to enhance methods of recovering critical materials for energy, defense and manufacturing applications.
ORNL researchers have identified a mechanism in a 3D-printed alloy – termed “load shuffling” — that could enable the design of better-performing lightweight materials for vehicles.