121 - 130 of 164 Results
In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.
In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.
In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.
Traditional thermosetting polymers are widely used due to their excellent stability and mechanical performance. However, these materials are typically derived from non-renewable petrochemical sources and are difficult to recycle, often ending up in landfills or incinerated.
This technology aims to provide and integrated and oxidation resistant cladding or coating onto carbon-based composites in seconds.