31 - 40 of 42 Results
Compliance in a part, work holding, or base plate is beneficial for certain processes, but detrimental for machining and material removal.
In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.
In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.
In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.
This technology aims to provide and integrated and oxidation resistant cladding or coating onto carbon-based composites in seconds.
Electric vehicle drive fluids must have a high dielectric constant to avoid current leakage or even short circuits. On the other hand, lubricants should possess sufficient conductivity to allow static electricity to be released.
Simurgh revolutionizes industrial CT imaging with AI, enhancing speed and accuracy in nondestructive testing for complex parts, reducing costs.