Manufacturing

In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.

Additively manufacturing of the windings with a conductor distributed in the cross-section according to the Hilbert curve provides many benefits as it allows for the reduction of the high-frequency losses due to the reduction of the effective winding conductor size.

In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.

Algorithm for increasing the throughput on a variety of configurations of multi-laser additive systems through intelligent assignment of work to the individual lasers.

Liners in Type-IV hydrogen storage tanks often fail due to hydrogen saturation, additional weight and design limitations due to expensive tooling for conventional molding technique.

In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.

Unlike conventional overmolding process, overmolding onto an AM part can result in highly optimized structures without significant increase in manufacturing cost.

Currently, there is no tool that can enable phase evolution as a function of simultaneous variations in alloy chemistry (multiple alloying elements) and time-temperature during sintering of powder metallurgy alloys.

The recycling process we proposed here is a modified hydrometallurgy method, which is efficient, facile, low- cost and environmentally friendly. Green organic acid and solvent are only two chemicals needed in the closed-loop recycling process.