21 - 30 of 44 Results
A bonded carbon fiber monolith was made using a coal-based pitch precursor without a binder.
New demands in electric vehicles have resulted in design changes for the power electronic components such as the capacitor to incur lower volume, higher operating temperatures, and dielectric properties (high dielectric permittivity and high electrical breakdown strengths).
Fiberglass, semi-structural insulation for recycled glass fiber and using a low cost silicon with pultruded rods, either fiberglass and a low cost resin, polyester for pultruded rods. It will reduce the use of wood, which is flammable, and still be structural.
Through the use of splicing methods, joining two different fiber types in the tow stage of the process enables great benefits to the strength of the material change.
Wire arc additive manufacturing has limited productivity and casting processes require complex molds that are expensive and time-consuming to produce.
As additive manufacturing technologies advance and 3D-printers get larger, there is a constant need for larger extruders with higher throughput to construct larger objects at reasonable time.
The first wall and blanket of a fusion energy reactor must maintain structural integrity and performance over long operational periods under neutron irradiation and minimize long-lived radioactive waste.
ORNL has developed a new hybrid additive manufacturing technique to create complex three-dimensional shapes like air foils and wind generator blades much more quickly.