71 - 80 of 101 Results
The solution proposed here is a modified carbon-based tile face that is mechanically combined with an insulative backing. The tile face is based on a material architecture to minimize weight and thermal conductivity while maximizing thermal stability.
Anisotropic bonded critical rare earth free permanent magnets in a polymer matrix fabricated using an additive manufacturing process.
Compliance in a part, work holding, or base plate is beneficial for certain processes, but detrimental for machining and material removal.
In additive manufacturing large stresses are induced in the build plate and part interface. A result of theses stresses are deformations in the build plate and final component.
In wire-arc additive manufacturing and hot-wire laser additive manufacturing, wire is fed into a melt pool and melted through the arc or laser process.
Liners in Type-IV hydrogen storage tanks often fail due to hydrogen saturation, additional weight and design limitations due to expensive tooling for conventional molding technique.
In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.