11 - 20 of 52 Results
Faults in the power grid cause many problems that can result in catastrophic failures. Real-time fault detection in the power grid system is crucial to sustain the power systems' reliability, stability, and quality.
With the ever-growing reliance on batteries, the need for the chemicals and materials to produce these batteries is also growing accordingly. One area of critical concern is the need for high quality graphite to ensure adequate energy storage capacity and battery stability.
Test facilities to evaluate materials compatibility in hydrogen are abundant for high pressure and low temperature (<100C).
Water heaters and heating, ventilation, and air conditioning (HVAC) systems collectively consume about 58% of home energy use.
Finite element (FE) numerical computation method is widely used to facilitate the design and optimization of manufacturing processes using two types of solvers, implicit and explicit.
Using all polymer formulations, the PIP densification is improved almost 70% over traditional preceramic polymers and PIP material leading to cost and times saving for densifying ceramic composites made from powder or fibers.
A bonded carbon fiber monolith was made using a coal-based pitch precursor without a binder.
This work seeks to alter the interface condition through thermal history modification, deposition energy density, and interface surface preparation to prevent interface cracking.
Additive manufacturing (AM) enables the incremental buildup of monolithic components with a variety of materials, and material deposition locations.
New demands in electric vehicles have resulted in design changes for the power electronic components such as the capacitor to incur lower volume, higher operating temperatures, and dielectric properties (high dielectric permittivity and high electrical breakdown strengths).