1 - 10 of 13 Results
A pressure burst feature has been designed and demonstrated for relieving potentially hazardous excess pressure within irradiation capsules used in the ORNL High Flux Isotope Reactor (HFIR).
Sintering additives to improve densification and microstructure control of UN provides a facile approach to producing high quality nuclear fuels.
The technologies provide a system and method of needling of veiled AS4 fabric tape.
High strength, oxidation resistant refractory alloys are difficult to fabricate for commercial use in extreme environments.
ORNL will develop an advanced high-performing RTG using a novel radioisotope heat source.
The use of Fluidized Bed Chemical Vapor Deposition to coat particles or fibers is inherently slow and capital intensive, as it requires constant modifications to the equipment to account for changes in the characteristics of the substrates to be coated.
In manufacturing parts for industry using traditional molds and dies, about 70 percent to 80 percent of the time it takes to create a part is a result of a relatively slow cooling process.
This technology combines 3D printing and compression molding to produce high-strength, low-porosity composite articles.
This technology is a strategy for decreasing electromagnetic interference and boosting signal fidelity for low signal-to-noise sensors transmitting over long distances in extreme environments, such as nuclear energy generation applications, particularly for particle detection.