31 - 40 of 122 Results
Estimates based on the U.S. Department of Energy (DOE) test procedure for water heaters indicate that the equivalent of 350 billion kWh worth of hot water is discarded annually through drains, and a large portion of this energy is, in fact, recoverable.
Technologies are described that are directed to polyphase rotary transformer for field excitation of electric machines.
Distortion generated during additive manufacturing of metallic components affect the build as well as the baseplate geometries. These distortions are significant enough to disqualify components for functional purposes.
Technologies directed to an LCC based induction cooktop architecture for non-ferromagnetic pan are described.
Contact
To learn more about this technology, email partnerships@ornl.gov or call 865-574-1051.
For additive manufacturing of large-scale parts, significant distortion can result from residual stresses during deposition and cooling. This can result in part scraps if the final part geometry is not contained in the additively manufactured preform.
The heat exchanger is a three-medium heat exchanger with phase change material (PCM) stored in the external fin tubes. It allows the refrigerant flowing inside the internal fin tubes and the air to
Output Current Estimation and Control in Primary Side LCC Secondary Side Series Compensated Wireless
Wireless charging of electric vehicles require the ability to control the output current in the power transfer system, but that is often not possible as the availability of signals from the secondary side to the primary side is difficult and not always feasible.
Lean-burn natural gas (NG) engines are a preferred choice for the hard-to-electrify sectors for higher efficiency and lower NOx emissions, but methane slip can be a challenge.
In additive manufacturing large stresses are induced in the build plate and part interface. A result of these stresses are deformations in the build plate and final component.