21 - 30 of 49 Results
Using all polymer formulations, the PIP densification is improved almost 70% over traditional preceramic polymers and PIP material leading to cost and times saving for densifying ceramic composites made from powder or fibers.
The technologies provide a system and method of needling of veiled AS4 fabric tape.
Quantifying tool wear is historically challenging task due to variable human interpretation. This capture system will allow for an entire side and the complete end of the cutting tool to be analyzed.
New demands in electric vehicles have resulted in design changes for the power electronic components such as the capacitor to incur lower volume, higher operating temperatures, and dielectric properties (high dielectric permittivity and high electrical breakdown strengths).
Fiberglass, semi-structural insulation for recycled glass fiber and using a low cost silicon with pultruded rods, either fiberglass and a low cost resin, polyester for pultruded rods. It will reduce the use of wood, which is flammable, and still be structural.
Through the use of splicing methods, joining two different fiber types in the tow stage of the process enables great benefits to the strength of the material change.
Wire arc additive manufacturing has limited productivity and casting processes require complex molds that are expensive and time-consuming to produce.
As additive manufacturing technologies advance and 3D-printers get larger, there is a constant need for larger extruders with higher throughput to construct larger objects at reasonable time.
ORNL has developed a new hybrid additive manufacturing technique to create complex three-dimensional shapes like air foils and wind generator blades much more quickly.