Skip to main content
SHARE
Publication

Co-, Ni- and Fe-rich grain-boundary phases enhance creep resistance in θ′-strengthened Al-Cu alloys

by Jie Qi, Sumit Bahl, David Dunand, Amit Shyam, Jovid Rakhmonov
Publication Type
Journal
Journal Name
Materials Science and Engineering: A
Publication Date
Page Number
147052
Volume
913

Microstructural evolution and creep response were investigated in the cast Al-5.0Cu-0.3Mn-0.2Zr (wt.%) alloy with and without addition of slow-diffusing, intermetallic-forming elements Fe, Ni, or Co. Baseline Al-5.0Cu-0.3Mn-0.2Zr alloy exhibits high creep resistance at 300 °C, up to ∼75 MPa, which is attributed to high-aspect-ratio, intragranular θ′-Al2Cu precipitates that effectively suppress dislocation climb. However, θ′-Al2Cu precipitate-free zones form along grain boundaries upon heat treatment, whose extent is amplified during subsequent creep. Such weak regions experience dislocation creep, leading to strain localization and acceleration of grain-boundary sliding. Adding Ni and Co, individually or in combination, leads to the formation of grain-boundary precipitates (Al9Co2, Al3Ni2) which are resistant to coarsening, thus suppressing the formation of θ′-Al2Cu precipitate-free zones. This microstructure provides high creep resistance at stresses up to 75–80 MPa, with strain rates much lower than in unmodified Al-5.0Cu-0.3Mn-0.2Zr. Adding Fe, which results in extensive decoration of grain boundaries with coarsening-resistant Al7Cu2Fe, and then increasing the Cu content to compensate for the Cu loss to this new phase, leads to a new Al-7.4Cu-1.6Fe-0.3Mn-0.2Zr alloy with creep resistance at 300 °C that surpasses known cast aluminum alloys. Adding Fe to improve the creep resistance of Al-Cu alloys is both cost-effective and sustainable. Our findings offer guidelines applicable to various alloy systems on controlling the evolution of precipitate-free zones and its ensuing effects on creep deformation.