Skip to main content

Additively Manufactured Single-Use Molds and Reusable Patterns for Large Automotive and Hydroelectric Components...

Publication Type
Journal Name
International Journal of Metalcasting
Publication Date
Page Numbers
356 to 364

Additive manufacturing (AM) has the potential to reduce costs in the casting industry, particularly for large parts (i.e., components with any dimension > 12 in.). Here, pilot-scale production case studies of hydroelectric and automotive parts were used to evaluate two AM-enabled casting methods: the direct printing of sand molds by binder jet and printing of reusable cope and drag patterns for sand casting. An additional benefit was found when additively manufactured patterns were used in combination with heat-treat free aluminum alloys, to produce castings of complex hydrodynamic surfaces. These parts previously required production via subtractive machining due to part distortion induced by the quench step of heat treatments. The machine types used for the three case studies are sand-binder jet, high-resolution polymer fused deposition modeling (FDM), and big area additive manufacturing (BAAM) FDM in combination with CNC machining. Each method demonstrated distinct advantages over traditional casting practices in particular use cases. Single-use molds show great reductions in start-up cost to produce one-off or legacy parts, and additively manufactured impression patterns show promise for innovating the tooling design process for complex geometry and large castings.