The influence of 180° ferroelectric domain wall width on the threshold field

Abstract

e ideal 180° ferroelectric walls that are a unit cell wide 0.5 nm, real walls in ferroelectrics have been reported to be many nanometers wide 1–10 nm. Using scanning nonlinear dielectric microscopy of lithium niobate LiNbO3 and lithium tantalate LiTaO3 ferroelectrics, we show that the wall width at surfaces can vary considerably and even reach 100 nm in places where polar defects adjoin a wall. The consequence of such variable wall widths is investigated on the specific property of threshold field required for wall motion. Using microscopic phase-field modeling, we show that the threshold field for moving an antiparallel ferroelectric domain wall dramatically drops by two to three orders of magnitude if the wall was diffuse by only 1–2 nm, which agrees with experimental wall widths and threshold fields for these materials. Modeling also shows that wall broadening due to its intersection with a surface will influence the threshold field for wall motion only for very thin films 1–10 nm where the surface broadening influences the bulk wall width. Such pre-existing and slightly diffuse domain walls with low threshold fields for wall motion may offer a general mechanism to explain significantly lower experimental coercive fields for domain reversal in ferroelectrics as compared to the thermodynamic predictions.