November 2012

Journal

The investigation of die-pressing and sintering behavior of ITP CP-Ti and Ti-6Al-4V powders

By:
Chen, Wei ; Yamamoto, Yukinori ; Peter, William H; Clark, Michael B; Nunn, Stephen D; Kiggans Jr, James O; Muth, Thomas R; Blue, Craig A; Williams, James; Fuller, Brian; Akhtar, Kamal
Journal Name:
Journal of Alloys and Compounds
Page Number:
440-447
Volume:
541
Issue Number:
N/A
Publication Date:
November 2012
View DOI Listing:
https://doi.org/10.1016/j.jallcom.2012.06.131

Abstract

This paper investigated the die-pressing and sintering behavior of the low-cost CP-Ti and Ti-6Al- 4V powders made by the Armstrong Process®. The Armstrong powders have an irregular coral like, dendritic morphology, with a dendrite size of approximately 2-5 m. As-received as well as milled powders were uniaxially pressed at designated pressures up to 690 MPa to form disk samples with different aspect ratios. In the studied pressure range, an empirical powder compaction equation was applied to linearize the green density – pressure relationship, and powder compaction parameters were obtained. The Armstrong Ti-64 powder exhibited a significantly higher sinterability than the CP-Ti powder. This was explained to be due to the higher diffusivity of V at the sintering temperature. The Ti-64 samples with a green density of 71.0% increased to 99.6% after sintering at 1300oC for 1 hour. An ex-situ technique was used to track the powder morphology change before and after sintering.