Home Introduction Contacts Supported File Types System Requirements Try It Get It Configure Your System Special Applet Instructions SCALE

SUPPORTED FILE TYPES

Javapeño supports the following data file formats:

• TSUNAMI Sensitivity Data:
  • TSUNAMI-1D data in TSUNAMI-A format (2D Plot)
  • TSUNAMI-3D data in TSUNAMI-B format (2D Plot)
• KENO V.a and KENO-VI Data:
  • KMART data files from KMART and KMART6 (2D Plot)
• XSDRNPM Data
  • Data generated in Input Dump File, Balance Table File, and Activity Data File (2D Plot)
• SMORES Data
  • Effectiveness functions and density functions (2D Plot)
• ICSBEP Data
  • International Handbook of Evaluated Criticality Safety Benchmark Evaluations sensitivity data (2D Plot)
  • International Handbook of Evaluated Criticality Safety Benchmark Evaluations spectral data (2D Plot)
• CENTRM Flux Tab1 Data
  • Pointwise flux data generated by CENTRM (2D Plot)
• CENTRM Pointwise Data
  • Pointwise cross-section data for CENTRM (2D Plot)
• COVERX Data
  • Multigroup cross-section covariance data (3D Plot)
  • Multigroup cross-section covariance data standard deviation (2D Plot)
• AMPX Data
  • Multigroup cross-section data (both 2D and 3D plot)
• General 2D Plot Data
  • Supports a general format for viewing 2D data from other sources
• General 3D Plot Data
  • Supports a general format for viewing 3D data from other sources

The basic 2D plotting capabilities of Javapeño were adapted from the Ptplot package. The basic 3D plotting capabilities of Javapeño were adapted from FreeHEP's lego plot demo.

Oak Ridge National Laboratory DOE-Oak Ridge Search Feedback Disclaimer