ASHRAE TC 4.7 2001 “Modeling two-and three dimensional heat transfer through composite wall and roof assemblies in transient energy simulation programs” Report from the research project 1145-TRP.
Balcomb J.D., R.D. McFarland - 1978 “Passive testing in Los Alamos” Los Alamos National Lab. Report LA-UR-7B-1178.
Balcomb J.D., C.E. Kosiewicz, G.S. Lazarus, R.D. McFarland, Wray W.O. - 1983 “Passive Solar Design Handbook” vol.3 Los Alamos National Lab. ISBN 0-89553-106-2
Burch, D.M., W.L. Johns, T. Jackobsen, G.N. Walton, and C.P. Reeve 1984-a. “ The effect of thermal mass on night temperature setback savings” ASHRAE Transactions vol. 90. Part 2.
Burch D.M., K.L. Davis, and S.A. Malcomb 1984-b.”The effect of wall mass on the summer space cooling of six test buildings.” ASHRAE Transactions vol. 90. Part 2.
Burch, D.M., D.F. Krnitz,, and R.F. Spain 1984-c. “The effect of wall mass on winter heating loads and indoor comfort - An experimental study.” ASHRAE Transactions vol. 90. Part 1.
Christian, J.E. 1983 “Thermal envelope field measurements in an energy-efficient office and dormitory” ORNL/Tm 8571.
Christian J.E. 1984 “Cooling season performance of an earth-sheltered office/dormitory building in Oak Ridge, Tennessee”. ORNL/CON-151
Christian J.E. 1985 “Detailed Thermal Perfoemrnce Measurements and Cost Effectiveness of Earth-Sheltered Construction: A Case Study” ORNL/CON-186
Christian, J. E. 1991. “Thermal Mass Credits Relating to Building Energy Standards,” ASHRAE Transactions, Vol. 97, Part 2.
Courville G. Bales E. “ Proceedings of the Building Thermal Mass Seminar 1982" ORNL CONF-8206 130.
Hasting, S. R. 1977. “Three Proposed Typical House Designs for Energy Conservation Research.” NBSIR 77-1309, National Bureau of Standards, Gaithersburg, Md.
Huang, Y. J., Rirschard, J., Bull, S., Byrne, I., Turiel, D., Wilson, C., Sui, H., and Folley, D.. 1987. “Methodology and Assumptions for Evaluating Heating and Cooling Energy Requirements in New Single-Family Residential Buildings, Technical Support Document for the PEAR Microcomputer Program,” LBL-19128, Lawrence Berkeley Laboratory, University of California, Berkeley, Ca.
Kosny J., Desjarlais, A. O., and Christian J. E. December 1998. Dynamic Thermal Performance of Concrete and Masonry Walls, Building Thermal Envelopes VII Conference, ASHRAE, BETEC, DOE, ORNL.
Kosny J., Christian J.E., Desjarlais A.O., Kossecka E., Berrenberg L.1998a “ The Performance Check between Whole Building Thermal Performance Criteria and Exterior Wall; Measured Clear Wall R-value, Thermal Bridging, Thermal Mass, and Air-tightness” - paper presented at 1998 ASHRAE Toronto Meeting. ASHRAE Transactions, V. 104, Pt. 2.
Kosny J., Kossecka E., Desjarlais A. 2000 “ Dyanmic Thermal Modeling of Complex Building Envelope Assemblies; Some Accuracy Problems” Proceedings of International Building Physics Conference, Enidhoven, The Netherlands, September 2000.
Kossecka E., Kosny J. 1998. The effect of insulation and mass distribution in exterior walls on the dynamic thermal performance of whole buildings, Conference Proceedings: „Thermal Performance of the Exterior Envelopes of Buildings VII”, December 6-10, Clearwater Beach, Florida, 721-731.
MEC -1995 “Model Energy Code - 1995 Edition” Prepared by Council of American Building Officials., Falls Church, Virginia.
NAHB Research Center 1999 “Insulating Concrete Forms: Comparative Thermal Performance” prepared forU. S.Dept. of Housing and Urban Development. August 1999.
Robertson, D.K., and J.E. Christian 1985 “Comparison of four computer models with experimental data from test building in northern New Mexico” ASHRAE Transaction Vol.91
Sherman, M. H., and Grimsrud, D. T. October 1980. Measurement of Infiltration Using Fan Pressurization and Weather Data, LBL-10852, Lawrence Berkeley Laboratory, University of California, Berkeley, Ca.
Steven Winter Associates - 1981 “Passive Solar Construction Handbook” U.S. DOE. Report DE-AC02-79CS30166.
© Oak Ridge National Labs and Polish Academy of Sciences
Updated August 13, 2001 by Diane McKnight