Booting Tru64 4.0f from CD

[Rolf-Peter Kienzle <kienzlep@xxxxxxxxxxxxxxx>]

Dear managers!

When trying to boot a PW433 from the V4.0f CD the following messages are
displayed infinitely after a while:

ataintr
Interrupt not expected
cam_LOGGER: CAM-ERROR packet
cam_logger: bus 0 target 0 lun 0
Flushing buffer - non-exptd intr
flush buffer for non-exptd intr
	.	.
	.	.

The machine has got the usual ELSA Gloria Synergy Graphics option, a 9.1
GB Quantum disk on a Qlogic controller an a CD-ROM which is recognised
as dqa1 (?). The SRM console firmware identifies itself as V7.0-11 so I
consider it up to date.

Does anyone out there know what might be wrong?


Regards 


Peter

-- 
Dipl.-Phys. Rolf-Peter Kienzle
Dept. of Remote Sensing and Land Information Systems
University of Freiburg, D-79085 Freiburg, Germany
Tel/Fax +49 761 203 8643/8640 e-mail: kienzlep@xxxxxxxxxxxxxxx